Tuesday 15 April 2014

Top Tip Tuesday ~~ Tutorial ~~ How to make Wrapped Loops

How to make:  Wrapped Loops



You will need:

Wire cutters
Round nose pliers
Flat nose pliers
Chain nose pliers

Head pin
Beads


1.  Onto a headpin place on desired bead(s), do not trim headpin as you did in the turned loop.





2.  Grasp the headpin with round nose pliers, approx. 4mm above the bead





3. Start to pull the wire around the blade of the round nose pliers, using your fingers or chain/flat nose pliers, to form the loop.





4. The wires should cross over





bend back the upright wire to centralise the loop (as in the turned loop)             

    




Tip: At this point you need to attach to the chain and/or earwire, if do not want to use a jump ring to attach the bead component.



5. Now take the chain nose pliers and hold the loop,




Grasp the loose end with a second pair of pliers (I use flat nose pliers but you can use whatever you have), pull this wire around the upright wire; ensuring this wire is perpendicular to the upright wire.



Tip:  If the wire is not perpendicular you will get sloping or diagonal wraps and they may not be neat and tidy. Using the flat nose pliers, straighten this wire so it sits perpendicular.



  
6.  Continue to wrap the wire around the upright until you get to the bead, the usual amount of wraps is 3 but it can be any number you want it to be, you are only limited by the length of wire left on the headpin.





Tip: While winding take the wire to the top (still holding the loop with the chain nose pliers), let go with the flat nosed pliers and reposition your hand by grasping the wire from the back and carry on by pulling the wire round and towards you 







and up 



let go again and reposition as before to pull upwards to the top once again






Don’t try and complete a wrap all in one go!





7.  Take the cutters and trim off the wire end as close to the base wire as possible.




Tip: You may need to straighten the loop after the wraps are complete as it can sometimes tip over slightly. Put the round nose pliers back into the loop to do this, as if re-turning it again.


 
Also the base wire can bend over slightly, just use your flat-nose pliers to straighten the loop so it becomes upright again.  

    

8.  Take the chain and/or flat nose pliers and tuck the end in by squeezing it down









slowly moving round the wire so no more wire is sticking out, until it is neat.










A Wrapped Loop





The wrapped loop is a little difficult to get right but with practice will become easier.


I hope you find this tutorial helpful and if you have any difficulties or any questions please contact me, I am happy to help.


Once you have mastered the wrapped loop, it is a very useful skill to have and can be used in many different ways within different types of jewellery making, earrings are a very common use but can also be used in bracelets, pendants/necklaces for linking or connecting components together, maybe in brooches and even in other types of accessories.




 
Bangle on a wire, connection to chains.



 
Beaded Finial on the clasp of a bangle
 
 




 
Necklace - Beads on a wire, connection to chain





 
Bookmark -  Connections between beads





Next time I will cover Coiling (I do not use a Gizmo) all done by hand.


Until then lots of practising required.  80))


E x






No comments:

Post a Comment

I love to hear from my lovely readers, so do please leave any message, comments or just say Hi!